A new PSU... KPO SPS-30-II ... PART 1: The good, the bad and not so bad at all

A while back I bought a KPO SPS 30-II .... And I promised to write something about it in a few weeks... well.. a few weeks became a few months....

So without any more delay..... here it is , a 59 euro 30 amps power supply......
yeah you read it right... 59 euro..... (thats dirt ass cheap for dutch standards)

It looks like this.....

Not too bad in my opinion, nice clear meters, and if you take the price into account, it's beautiful.
It feels well build as well , as only the front s plastic, the rest is all metal....
It does have this nasty warning at the top back.....

I guess this is a bit over exaggerated as the construction will not allow this to become too hot... (airflow is continues, and the components are on the bottom and not at the top)

Soooooo.... Let's take a look inside....
Well yes.... not that quick though.... to get inside you need to take out  >>13<< screws.
My 1st thought was that this was a tad too much.... but no.... as soon as you have them all out you will notice that without the 13 screws, the structural integrity has completely gone... and it feels not well build at all anymore...  Not that this is a problem, i do not know any people that would take it apart, and then put it on a shelf to use it....

So now we can take a look inside....

At first glance, this PSU looks really nice... A bit like the other proper build KPO i wrote about earlier... No spilled heat paste or white glue stuff...
But after about 30 seconds i noticed a missing part..... AGAIN!!!

In the picture above, again, the clixon is not installed.... KPO clearly did want to put it in as the 2 holes give away their intentions.... (ohh by the way, the heat past you see in this pic, is the only you will find in this unit)
I do not know why they will not just add this.... the PSU is 59 euro, add the stupid thing and make it 64,95... still cheap...

So how does it perform... As I did not have time to have it run at high current for a while, I measured the DC voltage with no load (just 2 small vhf/uhf transceivers powered on) and 1 measurement with a load of around 8 amps....

As you can see , with 8 amps , the PSU drops 0.06 volts..... I think that this will do perfectly for all my VHF/UHF sets.... (I will measure some higher currents on all my PSU's in the near future)

Part 2 , adding the missing part will come soon :)

73's

Alex
PA1SBM